Unpacking

First, open the box. Inside is your blu starter kit. It should include:

• 1x blu pack (it holds 5 cartridges & can charge your batteries)
• 2x blu batteries
• 1x atomizer
• 1x spare atomizer
• 1x wall charger
• 1x USB charger
• 1x carton of 25 assorted flavor cartridges (your choice of strength)

Set Up & Initial Use

• Fully charge the batteries and blu pack before your first use.
• There should be one battery and one atomizer that is pre-assembled with an empty cartridge. Replace the empty cartridge with a new, full one, by placing it firmly on the atomizer. Twist this new cartridge slightly, to ensure it is secure.
• Your blu is always on so you can press it to your lips and inhale. The blue LED light at the tip glows like a real cigarette, so you know it is working.

Charging the blu Pack

• The pack and batteries can be charged using a standard wall outlet, or a computer's USB port.
• To charge the pack using a wall outlet, simply plug the wall charger into the outlet and connect the opposite end to the bottom of the pack. When the blue light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.
• To charge the pack using the enclosed USB charger, unplug the USB cord from the wall charger and connect one end of the cable to the pack and the other to the USB port. When the blue light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.

The blu Pack as a charger

The unique thing about the blu pack is that it doubles as a battery charger.

• The second round "port", from the right, (inside the pack) is a battery jack.
• Screw the battery into the jack, until it is snug. The blue LED light on your battery will flash and the blue light on the side of the pack will light up. When the light is on it means the battery is charging. When the light turns off, the battery is completely charged.
• Simply unscrew the battery from the jack and leave it in the same slot in the pack. If the battery is left screwed into the jack, after charging, it will drain the remaining charge from the blu pack.

Charging Batteries

• To charge the batteries using a wall outlet, place the battery into the USB charger.
• Connect the male end of the charger to the female end of the cordless wall adapter and plug it into the nearest outlet. A red charger light indicates the battery is charging. The light turns blue when the battery has been fully charged and can be removed from the charger.
• To charge the batteries using your computer, simply screw the battery into the USB charger, and then plug the charger into any available USB port. The blue LED light at the end of the battery will flash and the USB charger light will turn red letting you know it is charging. When the charger light turns blue, the battery is fully charged.
• *NOTE - Charging your blu pack and batteries to capacity takes approximately 1-2 hours.

Replacing Batteries

Each battery should provide approximately two cartridges worth of full-flavored enjoyment between charges. The blu pack will refresh your batteries up to 6 times before needing a recharge.

• When a battery is drained, the blue LED at the end of the battery will blink 30 times intermittently.
• To replace the empty battery, firmly grasp the cartridge in one hand and unscrew the battery from the atomizer/cartridge.
• Reattach a freshly charged battery from your blu pack, onto the atomizer. You can now recharge the empty battery by using one of the above charging methods.
• Remember to always unscrew a newly charged battery from the blu pack's jack when the blue light goes out.

Note: During use, the LED light will flash 10 times to warn you that you are overusing your blu and you should take a break. This does not affect performance and does not mean you should recharge.

Replacing Cartridge

On average, each individual cartridge supplies enough nicotine and premium flavoring to accommodate approximately 80 puffs. When the cartridge no longer produces vapor, you'll know it's time for a replacement.

• To replace the cartridge, hold the battery with one hand and pull off the empty one.
• Check the atomizer for any foil residue and gently brush it aside using your fingers.
• Firmly apply a full cartridge to the atomizer and twist it slightly to make sure it is secure.